Publisher profile
Municipality of Southwest Middlesex
Applies to: Southwest Middlesex, Middlesex County, Ontario, Canada
Is this your organization? Raise a concern or correction
Item standards
- SD-1Utility Locations for Residential Roads
- SD-10Standard Single and Double Entrance Driveway
- SD-11Standard for Street Curve
- SD-12Capacity Factor for Uncertain Development
- SD-13Sanitary Sewage Flows Gross Area Basis
- SD-14Pipe Beddings Detail (1 of 2)
- SD-15Pipe Bedding Detail (2 of 2)
- SD-16Rainfall Intensity-Duration Curve for Storm Sewer Design
- SD-17600x840 Precast Concrete Curb Inlet Catchbasin
- SD-18Lot Servicing
- SD-19Water Sampling Station
- SD-2Standard R.O.W. Residential Asphalt - Ditches
- SD-20Private Drain Connections at Street Line
- SD-21Typical Lot Drainage Plan
- SD-22Plan and Profile Legend
- SD-23Standard Mechanical Joint Offset Installation Using Tiebolt Couplings
- SD-24Typical Restraint Details
- SD-25Insulation of Watermain and Offsets
- SD-26Minimum Easement Width
- SD-3Utility Locations for Industrial Roads
- SD-4Standard for Circular Cul-de-Sac
- SD-5Industrial Cul-de-Sac
- SD-6Collector/Arterial Roadway Residential
- SD-7Local Roadway Residential
- SD-8Industrial Roadway
- SD-9Walkway Details
- Southwest Middlesex Design and Construction StandardsMunicipality of Southwest Middlesex Design and Construction Standards
Reference only. Always verify before you specify.
This directory is compiled from publicly available sources and may contain errors, omissions, or out-of-date entries. FieldWorks does not publish, approve, certify, or endorse any standard or product; approval listings are reproduced from the issuing authority's own published lists. Confirm the current edition with the publisher or authority before relying on it in a contract, and use the flag buttons in the directory to report anything that looks wrong. Use of the directory is subject to our Terms of Service, including the prohibition on bulk extraction and automated scraping.
Put this standard to work.
This same search is built into the FieldWorks Item Specification Composer, where a pick becomes a tender item with the reference, unit, and special provision already wired.